Audio Pro LV-HUB Spécifications télécharger pdf (Page 8)

MORE OR LESS BASS (ROOM ADAPTATION)

When placing LV33 in your home, you may experience too much or too

little bass, depending on where you place the speakers. To solve this,

LV33 has built in room adaptation (+10/-10 dB bass equalizer). By adjust-

ing bass levels, you can find a good bass balance that suits your room.

Generally, placing LV33 in a corner will reproduce more bass, placing

LV33 in the middle of your room less bass. With room adaptation you can

place LV33 anywhere you like, and then adjust bass levels to your liking.

ADJUST BASS EQ:

1. Use buttons on speaker (not remote)

2. Press button “House Code” and hold it pressed

3. While holding “House Code” button pressed, adjust bass EQ with

VOL + and –. Press + to increase bass, – to decrease bass

Display will show your settings: -10, -9, -8 … 0 … 8, 9, 10

RESET SPEAKER

Returning to factory settings (volume 17, bass EQ 0):

Turn off speakers with remote. Turn on again and press MUTE on remote

while LED flashes. Push Mute once more. Now speaker pair (or all speak-

ers in same Zone) are in default setting.

LEFT, MONO AND RIGHT

On the rear of LV33 is a switch for left, mono and right. Normally two

LV33 speakers are used in one room for stereo sound. Set one speaker to

RIGHT, the other to LEFT.

NOTE: Only speaker set to RIGHT can receive commands from remote.

MONO is used if you have only one LV33 in one room, and the other in

another room. Or very large room, or reception hall where all speakers

play in mono. Note that the speakers will reproduce sound in mono, not

stereo.

MONO MASTER

If you have your LV33 speakers set to MONO, you will need to make one

of them MONO MASTER to be able receive commands from the remote.

Setting one speaker as MONO MASTER:

1. Aim remote at desired speakers, push Zone INFO button for 5 seconds.

2. Display will show “111”. Now the speaker is mono master speaker.

To change back to slave mode mono speaker, push Zone info button on

remote again for 5 seconds, display shows “000”.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 67 68

Pas de commentaire

Audio Pro LV-HUB Spécifications Page 8